BMW F92 — repair instructions and wiring diagrams
Original BMW documentation for the F92 body — what is commonly known as BMW TIS: step-by-step repair and maintenance procedures with illustrations, tightening torques and specifications. Navigation follows the vehicle’s assemblies, as in the factory system.
This body series also has wiring diagrams (what is commonly known as BMW WDS): circuit diagrams, connectors and pinouts, component locations.
- Production years
- 2017–2022
- Body types
- coupé
- Documents
- 6,805
- Wiring diagrams
- available
Open the F92 catalogue Search by title
Model variants
Documents apply to a specific variant: after picking the body you specify engine, drive and build date, and irrelevant procedures are filtered out.
- M8
Example procedures for the F92
One of the most detailed procedures from each section — so you can see what is actually inside. The full list opens after a free registration.
- Replacing the crankshaft (engine removed)11 Engine
- Remove and install / replace wiring harness section, sensor system module cylinder 5-812 Engine electrical system
- Removing and installing/replacing both exhaust manifolds18 Exhaust system
- Completely removing and installing front axle with engine and transmission31 Front axle, front suspension
- Replacing left engine support bracket22 Engine and transmission mounting
- Replacing oil / coolant temperature sensor13 Fuel preparation and control
- Remove and install automatic transmission24 Automatic transmission
- Removing and installing/renewing evaporator (Heating and air-conditioning unit removed)64 Heating and air conditioning
- Removing and installing / replacing lower section of steering shaft32 Steering and Wheel Alignment
- Replacing carrier for dashboard51 Body equipment
- Removing and installing head-up display62 Instruments
- Replacing rear axle support (Flat rate unit without wheel alignment)33 Rear axle, rear-wheel drive, guide
- Replace front left or right door41 Body
- Replacing purge air line, front16 Fuel supply
- Replacing the coolant hose transmission breather on expansion tank (draining and topping up coolant, see 17 00 ...) (to cylinder head)17 Cooling
- Removing and installing or replacing airbag module on passenger's side72 Body parts and accessories
- Removing/installing/replacing seat and backrest frame for driver’s seat (M sport seat CFRP)52 Seats and motorcycle seat
- Replacing grooved ball bearing in propeller shaft centre bearing26 Propeller shaft
- Install the exchange transfer box27 Transfer box
- Replacing rear left or right spring strut37 Integrated Suspension Systems
- Service - spark plugs0 Maintenance and general note
- Replacing the centre console operating facility (after vehicle diagnosis) (flat rate specification without programming/encoding, see 61 00 ...)61 General vehicle electrical system
- Replace airbag control unit65 Audio, navigation, information systems
- Replacing rear left or right brake caliper (Without break bleed)34 Brakes