BMW F96 — repair instructions and wiring diagrams
Original BMW documentation for the F96 body — what is commonly known as BMW TIS: step-by-step repair and maintenance procedures with illustrations, tightening torques and specifications. Navigation follows the vehicle’s assemblies, as in the factory system.
This body series also has wiring diagrams (what is commonly known as BMW WDS): circuit diagrams, connectors and pinouts, component locations.
- Production years
- 2018–2022
- Body types
- coupé SUV
- Documents
- 7,263
- Wiring diagrams
- available
Open the F96 catalogue Search by title
Model variants
Documents apply to a specific variant: after picking the body you specify engine, drive and build date, and irrelevant procedures are filtered out.
- X6 M
- X6 M Competition
Example procedures for the F96
One of the most detailed procedures from each section — so you can see what is actually inside. The full list opens after a free registration.
- Replacing the crankshaft (engine removed)11 Engine
- Removing and installing/replacing both exhaust manifolds18 Exhaust system
- Completely removing and installing front axle with engine and transmission (Flat rate unit without wheel alignment)31 Front axle, front suspension
- Replacing left engine support bracket22 Engine and transmission mounting
- Remove and install / replace wiring harness section, sensor system module cylinder 5-812 Engine electrical system
- Replacing oil / coolant temperature sensor (On the crankcase) (after vehicle diagnosis)13 Fuel preparation and control
- Removing and installing/replacing the oil return line for engine oil cooling (Part 1) (to oil sump)17 Cooling
- Removing and installing/renewing evaporator (Heating and air-conditioning unit removed)64 Heating and air conditioning
- Replacing rear axle support (Flat rate unit without wheel alignment)33 Rear axle, rear-wheel drive, guide
- Remove and install/replace torque converter ()24 Automatic transmission
- Removing and installing / replacing lower section of steering shaft32 Steering and Wheel Alignment
- Replacing carrier for dashboard51 Body equipment
- Replacing the front active anti-roll bar (after vehicle diagnosis) (flat rate specification without programming/encoding, see 61 00 ...)37 Integrated Suspension Systems
- Replacing the purge air line (draw off without fuel and fill)16 Fuel supply
- Removing and installing head-up display62 Instruments
- Replacing tailgate41 Body
- Removing and installing or replacing airbag module on passenger's side72 Body parts and accessories
- Removing and installing/replacing backrest frame for left rear seat52 Seats and motorcycle seat
- Replacing grooved ball bearing in propeller shaft centre bearing26 Propeller shaft
- Install the exchange transfer box27 Transfer box
- Removing and installing/replacing the panorama glass roof54 Slide/tilt sunroof and soft top
- Removing and installing/replacing steering wheel module control unit61 General vehicle electrical system
- Removing and installing/replacing rear left protective plate34 Brakes
- Removing and installing rear radar sensor short range left66 Distance system, Cruise control, remote operation