BMW E93 — repair instructions and wiring diagrams
Original BMW documentation for the E93 body — what is commonly known as BMW TIS: step-by-step repair and maintenance procedures with illustrations, tightening torques and specifications. Navigation follows the vehicle’s assemblies, as in the factory system.
This body series also has wiring diagrams (what is commonly known as BMW WDS): circuit diagrams, connectors and pinouts, component locations.
- Production years
- 2005–2013
- Body types
- convertible
- Documents
- 11,499
- Wiring diagrams
- available
Open the E93 catalogue Search by title
Model variants
Documents apply to a specific variant: after picking the body you specify engine, drive and build date, and irrelevant procedures are filtered out.
- 318i
- 320d
- 320i
- 323i
- 325d
- 325i
- 328i
- 330d
- 330i
- 335i
- 335is
- M3
Example procedures for the E93
One of the most detailed procedures from each section — so you can see what is actually inside. The full list opens after a free registration.
- Removing and installing/renewing evaporator (Heating and air-conditioning unit removed)64 Heating and air conditioning
- Removing and installing/replacing an injector of the injection system13 Fuel preparation and control
- Checking timing chain for elongation and replacing both timing chains (N47D K/U/O/T 0/1)11 Engine
- Remove and install transmission23 Manual gearbox
- Removing and installing roof module54 Slide/tilt sunroof and soft top
- Guideline for applying brake pad paste on brake pads and caliper carrier34 Brakes
- Unlocking and disconnecting different plug connections61 General vehicle electrical system
- Retrofitting component protection and checking function of angle fitting0 Maintenance and general note
- Removing and installing/replacing clutch (gearbox removed)21 Clutch
- Removing and installing automatic transmission (6HP26Z)24 Automatic transmission
- Removing and installing/replacing diesel particulate filter18 Exhaust system
- Removing and installing/renewing all spark plugs12 Engine electrical system
- Removing and installing complete front axle with engine and transmission (E9x-N55)31 Front axle, front suspension
- Removing and installing twin-clutch gearbox (GS7D36SG) S6528 Twin-clutch gearbox (DKG)
- Replacing front section of engine support to left wheel arch41 Body
- Replacing backrest release cable for front left or right seat52 Seats and motorcycle seat
- Bleed and fill cooling system with vacuum filling unit17 Cooling
- Removing and installing/replacing front seat belt (US version only)72 Body parts and accessories
- Individual parts/painting99 Paint
- Adjusting left or right front side window51 Body equipment
- Removing and installing propeller shaft (inserted) completely26 Propeller shaft
- Removing and installing or replacing fuel gauge sensor (diesel, right)16 Fuel supply
- Removing and installing / replacing rear left or right coil spring33 Rear axle, rear-wheel drive, guide
- Replacing release unit for trailer tow hitch71 Parts and accessories for engine and chassis