BMW F30 — repair instructions and wiring diagrams
Original BMW documentation for the F30 body — what is commonly known as BMW TIS: step-by-step repair and maintenance procedures with illustrations, tightening torques and specifications. Navigation follows the vehicle’s assemblies, as in the factory system.
This body series also has wiring diagrams (what is commonly known as BMW WDS): circuit diagrams, connectors and pinouts, component locations.
- Production years
- 2011–2019
- Body types
- sedan
- Documents
- 12,033
- Wiring diagrams
- available
Open the F30 catalogue Search by title
Model variants
Documents apply to a specific variant: after picking the body you specify engine, drive and build date, and irrelevant procedures are filtered out.
- 316d
- 316i
- 318d
- 318d xDrive
- 318i
- 320d
- 320d EffDyn Edition
- 320d xDrive
- 320i
- 320i EffDyn Edition
- 320i xDrive
- 325d
- 328d
- 328d xDrive
- 328i
- 328i xDrive
- 330d
- 330d xDrive
- 330e iPerformance
- 330i
- 330i xDrive
- 335d xDrive
- 335i
- 335i xDrive
- 340i
- 340i xDrive
- ActiveHybrid 3
Example procedures for the F30
One of the most detailed procedures from each section — so you can see what is actually inside. The full list opens after a free registration.
- Replacing all hydraulic valve clearance compensating elements11 Engine
- Remove and install / replace Module 1, sensor system engine wiring12 Engine electrical system
- Removing and installing/replacing heat exchanger for automatic transmission17 Cooling
- Replacing left engine support bracket22 Engine and transmission mounting
- Removing and installing high pressure pump13 Fuel preparation and control
- Completely removing and installing front axle with engine and transmission31 Front axle, front suspension
- Installing repair kit for sensor (After vehicle diagnosis) (without programming/encoding, see 61 00 ...)24 Automatic transmission
- Removing and installing/replacing clutch (gearbox removed)21 Clutch
- Replace the housing pan for the high-voltage battery unit (high-voltage battery unit removed)61 General vehicle electrical system
- Removing and installing electrical air conditioning compressor (without draw-off, evacuation and filling)64 Heating and air conditioning
- Removing and installing/replacing catalytic converter18 Exhaust system
- Servicing particulate filter0 Maintenance and general note
- Remove and install transmission23 Manual gearbox
- Guideline for applying brake pad paste on brake pads and caliper carrier34 Brakes
- Removing and installing the steering column32 Steering and Wheel Alignment
- Paintwork (2 and 3 coats)99 Paint
- Replace the pressure temperature sensor (after vehicle diagnosis)16 Fuel supply
- Replacing the telematics control unit under the headlining (With slide/tilt sunroof, after vehicle diagnosis) (FRU specification without programming/encoding, see 61 00...)84 Communication systems
- Remove and install the power window regulator in the left or right front door51 Body equipment
- Removing and installing or replacing flat motor for front left or right power window regulator67 Electric motor
- Replacing engine support with left wheel arch in front of bulkhead41 Body
- Remove and install propeller shaft (inserted at rear) completely (B48 hybrid drive)26 Propeller shaft
- Removing and installing gearshift lever25 Gearshift
- Replacing backrest cover for rear seat, centre52 Seats and motorcycle seat