BMW F49 — repair instructions and wiring diagrams
Original BMW documentation for the F49 body — what is commonly known as BMW TIS: step-by-step repair and maintenance procedures with illustrations, tightening torques and specifications. Navigation follows the vehicle’s assemblies, as in the factory system.
This body series also has wiring diagrams (what is commonly known as BMW WDS): circuit diagrams, connectors and pinouts, component locations.
- Production years
- 2014–2022
- Body types
- SUV
- Documents
- 7,568
- Wiring diagrams
- available
Open the F49 catalogue Search by title
Model variants
Documents apply to a specific variant: after picking the body you specify engine, drive and build date, and irrelevant procedures are filtered out.
- X1 sDrive18Li
- X1 sDrive20Li
- X1 sDrive25Li
- X1 xDrive20Li
- X1 xDrive25Le iPerformance
- X1 xDrive25Li
- X1 xDrive30Le
Example procedures for the F49
One of the most detailed procedures from each section — so you can see what is actually inside. The full list opens after a free registration.
- Replacing engine block completely (engine removed)11 Engine
- Removing and installing or replacing double clutch28 Twin-clutch gearbox (DKG)
- Replacing the radial shaft seal for the drive shaft (gearbox removed)27 Transfer box
- Replacing the radial shaft seal for the drive shaft (gearbox removed)23 Manual gearbox
- Removing and installing complete rear axle support (Flat rate unit without wheel alignment)33 Rear axle, rear-wheel drive, guide
- Removing and installing complete drive unit (Flat rate unit without wheel alignment)12 Engine electrical system
- Removing and installing/replacing catalytic converter18 Exhaust system
- Remove and install all injectors in the injection system13 Fuel preparation and control
- Removing and installing coolant radiator17 Cooling
- Checking/topping off oil level in rear electric machine transmission (Flat rate unit without wheel alignment)0 Maintenance and general note
- Set up high-voltage battery unit for replacement61 General vehicle electrical system
- Replacing switching unit (for work no. 24 00 000)24 Automatic transmission
- Removing and installing complete front axle31 Front axle, front suspension
- Guideline for applying brake pad paste on brake pads and caliper carrier34 Brakes
- Replacing engine support with left wheel arch in front of bulkhead41 Body
- Removing and installing/replacing front left or right seat belt (Roller)72 Body parts and accessories
- Removing and installing / replacing the delivery unit (61 l petrol)16 Fuel supply
- Removing and installing/replacing support for front bumper panel51 Body equipment
- Renewing the front left or front right spring strut shock absorber (EDC)37 Integrated Suspension Systems
- Leak detection with forming gas64 Heating and air conditioning
- Removing and installing output shaft (front inserted) completely26 Propeller shaft
- Removing and installing pedestrian protection sensor (impact absorber)65 Audio, navigation, information systems
- Replacing the rear seat backrest (frame), centre52 Seats and motorcycle seat
- Removing and installing gear selector switch25 Gearshift