BMW U11 — repair instructions and wiring diagrams
Original BMW documentation for the U11 body — what is commonly known as BMW TIS: step-by-step repair and maintenance procedures with illustrations, tightening torques and specifications. Navigation follows the vehicle’s assemblies, as in the factory system.
This body series also has wiring diagrams (what is commonly known as BMW WDS): circuit diagrams, connectors and pinouts, component locations.
- Production years
- 2021–2022
- Body types
- SUV
- Documents
- 7,196
- Wiring diagrams
- available
Open the U11 catalogue Search by title
Model variants
Documents apply to a specific variant: after picking the body you specify engine, drive and build date, and irrelevant procedures are filtered out.
- iX1 xDrive30
- X1 sDrive16i
- X1 sDrive18d
- X1 sDrive18i
- X1 sDrive20i
- X1 xDrive20d
- X1 xDrive20i
- X1 xDrive23d
- X1 xDrive23i
- X1 xDrive25e
- X1 xDrive28i
- X1 xDrive30e
Example procedures for the U11
One of the most detailed procedures from each section — so you can see what is actually inside. The full list opens after a free registration.
- Replacing the crankshaft11 Engine
- Removing/installing/replacing clutch cover28 Twin-clutch gearbox (DKG)
- Replacing the rear side excitation wire (Drive unit removed)12 Engine electrical system
- Replacing housing for heating and air-conditioning unit (heating and air-conditioning unit removed)64 Heating and air conditioning
- Replacing the petrol particulate filter18 Exhaust system
- Servicing particulate filter0 Maintenance and general note
- Removing and installing complete rear axle support (Flat rate unit without wheel alignment)33 Rear axle, rear-wheel drive, guide
- Removing and installing high pressure pump13 Fuel preparation and control
- Replacing carrier for dashboard51 Body equipment
- Replacing front axle support (Flat rate unit without wheel alignment)31 Front axle, front suspension
- Replacing the purge air line (draw off without fuel and fill)16 Fuel supply
- Replace electrical steering gear (EPS) (flat rate specification without wheel alignment) (after vehicle diagnosis) (without programming/encoding, see 61 00 ...)32 Steering and Wheel Alignment
- Replace radial shaft seal for output on transfer box27 Transfer box
- Replacing panoramic glass sunroof54 Slide/tilt sunroof and soft top
- Replace combined charging unit (CCU) (after vehicle diagnosis) (flat rate specification without programming/encoding, see 61 00 ...)61 General vehicle electrical system
- Replacing rubber mount for transmission mounting22 Engine and transmission mounting
- Removing and installing/replacing the coolant line between the lower coolant radiator and the coolant pump (Draining and topping up coolant, see 17 00 ...)17 Cooling
- Replacing the RDC control unit (After vehicle diagnosis) (without programming/encoding, see 61 00 ...)36 Wheels with tyres
- Replacing support for front passenger seat and backrest52 Seats and motorcycle seat
- Replacing grooved ball bearing in propeller shaft centre bearing26 Propeller shaft
- Removing and installing/replacing roof aerial (headlining lowered)65 Audio, navigation, information systems
- Removing and installing head-up display62 Instruments
- Replacing left LED headlight (basic LED headlight, LED headlight Adaptive Headlights)63 Lights
- Removing and installing/replacing front left or right protective plate34 Brakes